![]() This command is disabled by default AIS alarm is not reported during core failure events. ![]() This command has no keywords or arguments. No ais-core-failure Syntax Description Syntax Description To disable the AIS alarms, use the no form of this command. To enable AIS alarms to detect core failure events on a 8/16 T1E1 IM, use the ais-core-failure command in controller configuration mode. Negates the command or sets the value of the command to its Or disables the anti-jam mode on the GNSS module.Ĭonfigures the GNSS module based on the specified satellite Router(config-gnss)# 1pps polarity negative Related Commands Second is used to synchronize time with other sensors and is crucial for the ![]() Default polarity isĬommand was introduced on the Cisco ASR 903, Cisco ASR 907, and the Cisco ASR The valid values areĬonfigures the polarity as negative. To remove the 1pps configuration, use theĬonfigures the 1PPS cable compensation. Module on the Cisco ASR 903, Cisco ASR 907, and the Cisco ASR 920 routers, use Pulse per second parameters of the global navigation satellite system (GNSS) apply (satellite initial configuration).
0 Comments
Leave a Reply. |